カテゴリ: Alfaromeo

Role of Shock Absorbers Supporting Car Body (For Smooth Ride of 916 Alfa Romeo GTV with KONI STR. T)

The Alfa Romeo GTV, equipped with a 3.0-liter V-type engine, is normal and has a low ride height (vehicle height), and the front left and right suspension lower arm is "V-shaped" when viewed from the front.

Since the wheel side is upward from the body mounting part of the lower arm, the state is similar to the outer ring where the load is applied at the time of turning.

In a straight state, both the lower arm is left and right, because it is already the angle at the time of turning, when entering the curve as it is, it is clear that there is no room to step.

Simply lowering the vehicle's height can cause increased instability during turning.This is probably why the hardness (spring rate) of many low-down springs is extremely hard.

In addition, only the model that the attachment called the roll center adjuster is commercially available, the angle of the lower arm can be corrected relatively easily, and even if it is low down, it can be adjusted so that it is hard to become unstable.

Such an improper suspension is not considered normal and standard, i had replaced the normal spring before, but there is no change in vehicle height, it came to the conclusion that it would be a setting of emphasis on appearance.

Suspension Reassembly Improves Ride Comfort (Alfa Romeo GTV 3.0 V6 GF-916C1)

Three years have passed since then, and it is said that it has become more and more like lying to feel the impact that pushes up at the time of the step pass.

It is a specification that bump stroke is extremely small in normal.I think that the impact from the road surface is transmitted directly to the body by the coil spring in close contact between the lines.It is very wasteful that there is a stroke that is not used on the rebound side, but it is not realistic considering the time and cost of the spring design because the spring of the height of the high car than the normal has only the choice of bespoke.

I will try to replace the shock absorber which has deteriorated rapidly and aging.Koni STR.T, the only aftermarket product that is mass-produced. It's T.

The new shock absorber has the effect of supporting the heavy body by the repulsive force of the enclosed nitrogen gas.

You may want to imagine the Dunbar on a heavy rear gate.When there is a lot of gate opening and closing, the internal gas comes out and the repulsive force disappears, and the gate falls without supporting the weight.

In the case of suspension, it supports the body weight with a coil spring, and I think that the part that the shock absorber carries is numerically small.Shock absorbers tend to think separately from coil springs because the main function of the "damping force" does not occur when the suspension is stationary, but it is an important weight support bearer.

The body is horizontal, but I think that often have the image of the suspension tire is smoothly up and down to follow the road surface, unless it is an active suspension, in the combination of general coil spring + shock absorber, It would be difficult for a variety of inputs.

A good undercarriage car is stable with little body swing in the high-speed range, but in the low-speed range, when the uneven passage of the road surface, the car body unexpectedly goes up and down.I think that it is evidence that a heavy body is firmly supported.It does not operate extra and prepares for the next road condition, so there is little discomfort for the occupant.

When the nitrogen gas encapsulated in the shock absorber comes out over time, the damping characteristics are not so bad, but the ride comfort deteriorates.

At first it was a bit of a mess.If it comes to cause bump touch and spring line-to-line adhesion like this 916 spider, you will not be able to ride very much.Because it is a sports car, it is good to refresh the shock absorber without giving up.

Unfortunately, we couldn't improve the ride height of the car, but I think the ride comfort and quietness have improved dramatically.

Enjoy a comfortable sports car life.

Published by
ITS

最近の記事

The 5.5-Hour Myth: Repairing Oil Leaks on an Early KF Engine Daihatsu Hijet

The EF-type engine, Daihatsu's renowned 3-cylinder timing belt engine for light vehicles, has almost disappeared… 続きを読む

11/15/2024

Air Conditioner Repair in Scorching Heat: Replacing the Evaporator in a Palette MK21S and Memories of a Showa-era Gas Charger

This summer's relentless heat wave led to a record number of air conditioning repairs. Even… 続きを読む

11/4/2024

The Inherent Structural Vulnerabilities of Italian Cars (Wiper Malfunction, Alfa 147 Selespeed)

Shortly after the rainy season began, I received a call from an Alfa 147 late-model… 続きを読む

7/11/2024

Trends in Low-Viscosity Engine Oils, Engine Wear, and Countermeasures (Part 2)

In an engine where metal parts rub against each other, it's impossible to completely avoid… 続きを読む

4/30/2024

Trends in Low-Viscosity Engine Oils, Engine Wear, and Countermeasures

In an era where 0W-XX engine oils prioritizing fuel efficiency are becoming mainstream, we recently… 続きを読む

4/27/2024

An Unexpected Cause of Recurring Cooling System Issues (Subaru Sambar TV2 Overheating)

A Subaru Sambar, which had undergone repairs for cooling system issues (cooling fan malfunction) spanning… 続きを読む

1/4/2024